Napoleon NEFB30GL Installation And Operating Instructions Manual

Napoleon NEFB30GL Installation And Operating Instructions Manual Manual pdf 17 page image

W415-2166 / A / 06.29.1617ENNOTE: make sure your batteries arefully charged and installed correctlyin your remote control.6.1 OPERATING By REmOTE CONTROL1. plug in the power cord and turn on the power switch. You will hear the buzzer maketwo beep sounds, indicating that the power is turned on. press the " " key to startup the appliance. Flame and ember bed LEDs will turn on with the brightness level setto the highest as the default, the heating element will be off and the ceiling light willturn on the color starting to change gradually from bright blue.2. The “ ” button is the switch for entire appliance, when the appliance is turned off,press “ ”; the appliance is turned on with the same setting as the last time it hasbeen turned off. when the appliance is turned on, press “ ” button, the appliancepowers off; the ember bed, flame, heating element and background light are turnedoff. The other function buttons listed as following can only work under the conditionthat the “ ” is on. If the flame is off when the appliance is turned off, the brightnesslevel of the flame and ember bed LED are set to highest when “ ” is pressed to turnon the appliance.3. Button " ": when the flame and ember bed LEDs are turned on, press the button,and the light of the flame and ember bed will turn off. when the flame and ember bedLEDs are off, press the button to turn on the flame and ember bed LEDs.4. Yellow button “ ” controls the six brightness levels of the yellow LED flame lights;the brightness level changes with each press until you turn the light off completely;press the button again to repeat the cycle.5. Blue button “ ”, controls the six brightness levels of the blue LED flame lights; the brightness level changeswith each press until you turn the light off completely; press the button again to repeat the cycle.6. pink button “ ”, controls the six brightness levels of the pink LED flame lights; the brightness level changeswith each press until you turn the light off completely; press the button again to repeat the cycle.7. Ember button “ ”, controls the six brightness levels of ember bed LED lights; the brightness level changeswith each press until you turn the light off completely; press the button again to repeat the cycle.8. Button “ ”, press this button to turn on the heating element. The heating element starts to work on“hIgh” mode with the power at 1500w; press the button again to turn off the heating element.9. Button “ ”, press this button and the heating element starts to work on “LOw” mode (750w), press againand the heating element starts to work on “hIgh” mode (1500w). press again to repeat the cycle change.10. Button “ ”, press this to start TEMp mode. when "TEMp mode is on, the appliance automatically sets theroom temperature at 25°C. when the room temperature is above 25°C, the heating element shuts off. whenthe room temperature is below 22°C, the heating element starts working at 1500w. when the room tempera-ture is between 22-25°C, the heating element starts working at 750w.Caution: “hIgh” “LOw” “TEMp” buttons only work under the condition when “ ” is in the on position.when the appliance is on “hIgh” or “LOw” mode, the heating element is turned on all the time and thethermostat will not work.11. Button “ ” controls the ceiling light. Below shows the work mode of the ceiling light:Blue Amber Yellow Blinking Switch off