Napoleon NEFBD50H Installation And Operation Manual

Also see for CLEARion NEFBD50H: Installation and operation manual Installation and operation manual Quick start guide

Napoleon NEFBD50H Installation And Operation Manual Manual pdf 18 page image

W415-1767 / B / 11.23.17EN18finishing4.3 media installation4.3.1 log set and topaz glass installationA. Remove the fasteners from the log set assembly.B. Remove log set assembly.C. Install media tray using previously removed fasteners from thelog set assembly and secure with additional supplied fasteners (4screws for front media tray and 1 screw for back media tray).D. Carefully place acrylic crystals into the media tray, creating an evenlayer from side to side.E. Repeat steps on the opposite side.A. Carefully place the topaz glass between the log set assembly (front and back side).A. Ensure to remove all acrylic crystals from the ember bed.B. Remove fasteners from the media tray (FIG. 1).C. Remove media tray (FIG. 2).D. Install log set assembly (FIG. 3).E. Carefully place the topaz glass between the log set assembly.F. Repeat steps on the opposite side.Install the acrylic crystal media after framing the appliance and before installing the front glass.Install the log set and topaz glass after framing the appliance and before installing the front glass.If acrylic crystal media is installed:If log set assembly is installed:There are 2 media options for this appliance: log set and acrylic crystals. The log set assembly comes pre-installedwith the appliance and has to be finished with topaz glass. Refer to “log set and topaz glass installation” section. Ifdesired, this can be switched out with acrylic crystals. Refer to “acrylic crystal media installation” section.Ensure to vacuum up any topaz glass or acrylic crystals outside the media tray area before operation.Do NOT cover triangular covers on the back side of the unit. Blocking the triangular covers with media will alterthe flame appearance.note:Do NOT cover triangular covers on the back side of the unit. Blocking the triangular covers with media will alterthe flame appearance.note:FIG. 1 FIG. 2 FIG. 34.3.2 acrylic crystal media installation#12 x 5