W415-0676 / C / 08.01.1213This appliance was tested to CAN/ULC S610 and UL 127 Factory Built Fireplace Standards. This appliance hasmet the test criteria for Zero Clearance Installation to Combustible Surfaces and Certified to burn firewood only.Any 6” diameter chimney listed to these standards may be installed. In accordance with these standards, theappliance may also be connected to any chimney listed to CAN/ULC-S604 and CAN/ULC-S629 for Canada orUL-103HT for the United states.Installation of all types of factory-built chimney systems is to be in accor-dance with the chimney manufacturers installation instructions. An appropri-ate chimney manufacturers anchor base plate and anchor base plate gasketis required in order to initiate their system. Use the high temperature gasket,supplied, to seal between the anchor plate and the appliance top. Air cooledchimney systems are not recommended in colder climates.Complete installation instructions for Selkirk Ultra Temp Chimney for Canadaand Ultra Temp Platinum Chimney for USA, refer to: www.selkirkinc.com/prod-ucts/chimney.aspxA chimney venting the appliance shall not vent any other appliance. The minimum overall chimney height fromthe top of the appliance is 11 feet. The maximum overall chimney height from the top of the appliance is 34 feet.Factory-built chimney systems for use in dwellings constructed for three or more families must be enclosedabove the room in which the appliance is located. This enclosure must have a fire resistance rating equal to orgreater than that of the floor or roof assembly through which they pass.The chimney should not be built with an offset angle in excess of 45° in Canada and 30° in USA.Ensure that minimum clearances are maintained.Portions of the chimney that extend through accessible spaces must always be encased to avoid personalcontact with the chimney and thereby avoid damage to the chimney.The chimney must be supported at a maximum of 20 foot intervals (approx. 200 lbs/20 FT).63.4ANCHOR PLATEANCHOR PLATE GASKETAPPLIANCE TOPANCHOR PLATE FOR AFACTORY BUILT CHIMNEY! WARNINGALL VENTING CONNECTIONS MUST BE IN COMPLIANCE WITH THE CHIMNEY MANUFACTURERSINSTALLATION INSTRUCTIONS.4.1 CHIMNEY