Napoleon P450RB Instruction Manual

Contents

9Burner does not light.1/4"Barbecue flames flare up / Excessive smoke.Burners will not cross-light.Low heat / Low flame when burner turned tohigh.10. SEASONAL MAINTENANCETURN OFF THE GAS at the source and disconnect BEFORE SERVICING.1. This barbecue should be inspected at least annually. After a lengthy storage, the barbecue should be checked forgas leaks by brushing on a soap and water solution.(See #4 for leak testing instructions.)DO NOT USE OPEN FLAME. DO NOT USE IF A GAS LEAK IS DETECTED.2. Visually check the burner flames. Check to see that all burner ports are burning. Clean out any of the ports whichmay not be burning or are not burning properly. Ensure the insect screens are free of dust, insects or any other debris.AIR SHUTTER ADJUSTMENT: The air shutter is factory set and should not have to be adjusted under normal condi-tions. However, some extreme field conditions may exist that require adjustment. Main burner air shutters are set openat 1/8" (0.125"). The back burner is set at 3/8" (0.375") for natural gas, and fully open for propane.AIR SHUTTER ADJUSTMENT MUST ONLY BE DONE BY A QUALIFIED GAS INSTALLER!DO NOT ENLARGE BURNER PORTS WHEN CLEANING.3. The barbecue area must be kept clear and free of combustible materials, gasoline or other flammable vapours andliquids.4. The flow of combustion and ventilation air must not be obstructed. Keep the ventilation opening(s) of the cylinderenclosure free and clear from debris.11. TROUBLE SHOOTINGTURN OFF ALL GAS KNOBS AND VALVES BEFORE SERVICING THE BARBECUECheck whether burner will light with match.If YES, turn gas to off , ensure the electrode wire is connected tothe ignitor check for spark at electrode. Bend the tab to adjustthe gap if necessary. The gap should be ¼".If NO, check fuel gauge for sufficient gas. Check that valve is on.Check that gas line has no kinks.Ensure that the barbecue is being pre-heated prior to each use.Ensure that the barbecue is cleaned regularily - (See section 9.)Check that the sear plates are clean and installed correctly. (Seesection 17.) Check that the drip pan is clean so that grease canrun into grease tray. DO NOT LINE DRIP PAN WITH ALUMI-NUM FOIL.Are Lighting Procedures being followed? (See lighting instruc-tions.) Left burner lit first, then centre, and then right burner.Check that the carryover ports along the back of the barbecueare clean and free of grease.Natural - Ensure supply valve is in full open position. Pipe mustbe sized according to installation code.Propane - Check whether cylinder is turned on with burnervalve(s) in other than off position. Turn cylinder off; turn burner(s)off. Turn on cylinder. (See section 7.)