National Flooring Equipment 14420 Instruction Manual
                         | |
Contents
| 
Machine PreparationUNPACKING AND RE-PACKING THE MACHINEThe machine is boxed on a wooden pallet when shipped. To unpack the machine:1. Cut and remove bands holding the box to the pallet.2. Remove staples attaching the box to the platform at the bottom edge of the box.3. With two people, one at either end of the box, lift box straight up and off machine.4. Cut and remove bands securing the machine to the pallet.5. Remove back brace (Figure 1).6. Remove adjustment lever, bolt, and washer from the handle (Figure 1.1).7. Rotate handle to the user position. Insert the bolt through the handle bracket andhandle top (Figure 1.2).8. Place the washer and adjustment lever on the bolt. Adjust the handle to the desiredheight and tighten the adjustment lever.9. Connect the battery cables to the battery. Note: Connect the red cable to the (+)post and the black cable to the (-) post.10. Check machine fluid levels (engine oil). See Maintenance section. Note: If machinewas shipped by airfreight, add engine oil.11. Carefully, back the machine off the pallet.Reverse for re-pack. Use the original packing materials and container.TRANSPORTWhen transporting a propane-powered floor machine with the fuel cylinder installed,the cylinder should be securely fastened with the service valve closed and the machineshould be secured in the vehicle. Any propane fuel cylinders not installed should besecurely fastened to avoid movement and damage. Never store machine with cylinderinstalled or store spare cylinders in an enclosed vehicle. It is a good practice to checkpropane cylinders for overfilling before transporting them. If overfilled, correct beforeloading them in the vehicle by venting the excess propane outside in a safe area usingthe bleeder valve.MACHINE STORAGEOnly authorized, trained personnel should have access to propane cylinders and ma-chines.1. Remove propane fuel cylinder when not in use and store it outside in a storagecage in accordance with NFPA Handbook 58 CAN/CGAB149.2. Do not release orbleed propane inside the building. Please consult your local Fire Marshal to ensurethat you are in compliance with local fire codes.2. Store machine away from objects that may fall and damage it.3. Never store machine or fuel cylinders near an open flame or heat-producing device.4. Make sure machine is cleaned properly before storing.5. Never store machine with cylinders installed, or store spare cylinders in an en-closed van or trailer.6. Store machine in a dry location, temperature not to exceed 120°F (50°C).9FIG. 1FIG. 1.1FIG. 1.2 |
Related manuals for National Flooring Equipment 14420
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine