National Flooring Equipment 8274-4 Operating Manual
              | |
OperationFIG. 8ACCESSORY ATTACHMENT1. Tilt motor back to expose the underside of the machine.2. Clean foreign material from magnet prior to tooling installation.3. Place the individual tooling segments into two or four of the magnetic pockets. Becareful around pinch points, as the tooling segments will snap into place as themagnetic connection is made (Figure 8).4. For safety, depending on the condition of the surface being prepared, the individualtooling segments should be attached to the magnetic tooling holders using a singlemounting screw for each segment.Note: Use blanks in unused magnetic tooling pockets.Attaching The Velcro Plate AdapterThe Velcro plate adapter attaches magnetically to the Magnetic tooling plate and snapsinto place (Figure 9).Mounting Brazed Diamond and Polishing PadsThe brazed diamond and polishing pads are attached to the Velcro adapter plates (Fig-ures 10; 11).Mounting PCD’sPCD’s are mounted to the holder (Figure 12) with tooling screws. The holder and PCD’sare not magnetic, but are attached to the magnetic plates.Note: When setting the machine down into the operating position, hold the machinefirmly and set it down gently.FIG. 10FIG. 12FIG. 1110FIG. 9WARNING: WHEN ACCESSORIES ARE EXPOSED, NEVER OPERATEMACHINE. SERIOUS INJURY AND POSSIBLE PLATE DISENGAGEMENT COULDOCCUR.9241Assembly9245AdapterTOOL HOLDER & VELCRO ADAPTERCAUTION: DAMAGE TO ACCESSORIES AND MACHINE COULD OCCUR IFDROPPED. |
Related manuals for National Flooring Equipment 8274-4
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine