Installation and Configuration Chapter 2DAQCard-700 User Manual 2-2 © National Instruments CorporationPCMCIA SocketPortableComputerI/O CableINSERT CARDNATIONALINSTRUMENTSThe Software is the Instrument®CB-50I/O SignalsDAQCard ™-700Figure 2-1. A Typical Configuration for the DAQCard-700The DAQCard-700 is now installed. You are ready to make the appropriate connections to theI/O connector cable as described in Chapter 3, Signal Connections, and to install and configureyour software.ConfigurationThe DAQCard-700 is completely software configurable; refer to your software documentation toinstall and configure the software.If you are using NI-DAQ for PC compatibles, refer to the NI-DAQ release notes. Find theinstallation and system configuration section for your operating system and follow theinstructions given there.If you are using NI-DAQ for Macintosh, refer to the NI-DAQ documentation. Find theinstallation and system configuration section for your operating system and follow theinstructions given there.If you are using LabVIEW, the software installation instructions are in your LabVIEW releasenotes. After you have installed LabVIEW, refer to the Configuring LabVIEW section ofChapter 1 of your LabVIEW user manual for software configuration instructions.
