Chapter 5 Configuration UtilityPCI/PXI-1408 and NI-IMAQ for Win95/NT5-2 ©National Instruments CorporationFigure 5-1. StillColor Modes Dialog BoxesThe following is a description of each of the tabs in the IMAQconfutility.Description TabThe Description tab in the IMAQconf configuration utility is wherebasic information about your IMAQ board is stored, such as theinterface name, board type, base address, and interrupt the board uses.Figure 5-2 shows the information included in this tab. IMAQconfautomatically fills in this information.StillColorCompositePAL or NTSC Camera ModeStillColor RGBTri-CCD Camera Mode(Red, Green, and Blue) Linkedto Channel 1, 2, and 3StillColorDisabledMonochrome ModeAdvanced Camera Settings 2CLAMP Start/Stop and ZEROStart/Stop Are Specific toComposite ModeBasic Camera SettingsAttributes Are Common to All Three ModesAdvanced Camera Settings 1CLAMP Start/Stop and ZEROStart/Stop Are Specific toMonochrome and RGB ModesBasic StillColor SettingsAll the Attributes Are Specific to CompositeExcept Averaging and Image RepresentationAdvanced StillColor SettingsAll the Attributes Are Specific to CompositeExcept Hue Offset Angle
