<span role="presentation" dir="ltr" style="top:86.84%; left:58.21%">USB-6225</span>

National Instruments M Series Installation Manual

M Series

Safety Guidelines

Safety Guidelines for Hazardous Voltages

Hardware Symbol Definitions

Device Self-Calibration

Getting Started with M Series PCI Express Devices and the Disk Drive Power Connector

Getting Started with M Series USB Devices

USB Device Panel/Wall Mounting

USB Device Fuse Replacement

USB Device Security Cable Slot

Installing a Ferrite

DAQ Hardware

DAQ-STC2 and DAQ-6202

Cables and Accessories

Pin Cables

Pin BNC Accessories

SCXI

USB Device Accessories, USB Cable, and Power Supply

Signal Conditioning

Programming Devices in Software

I/O Connector Signal Descriptions

V Power Source

RTSI Connector Pinout

Analog Input Range

Analog Input Lowpass Filter

Analog Input Ground-Reference Settings

Configuring AI Ground-Reference Settings in Software

Analog Input Data Acquisition Methods

Analog Input Triggering

Connecting Analog Input Signals

Connecting Floating Signal Sources

When to Use Referenced Single-Ended (RSE) Connections with Floating Signal Sources

Using Non-Referenced Single-Ended (NRSE) Connections for Floating Signal Sources

Using Referenced Single-Ended (RSE) Connections for Floating Signal Sources

When to Use Differential Connections with Ground-Referenced Signal Sources

When to Use Referenced Single-Ended (RSE) Connections with Ground-Referenced Signal Sources

Using Non-Referenced Single-Ended (NRSE) Connections for Ground-Referenced Signal Sources

Field Wiring Considerations

AI Sample Clock Signal

Using an Internal Source

AI Sample Clock Timebase Signal

Using a Delay from Sample Clock to Convert Clock

AI Convert Clock Timebase Signal

Using an Analog Source

Using a Digital Source

AO Offset and AO Reference Selection

Minimizing Glitches on the Output Signal

Hardware-Timed Generations

Analog Output Triggering

Analog Output Timing Signals

Routing AO Sample Clock Signal to an Output Terminal

Getting Started with AO Applications in Software

Static DIO

Digital Waveform Acquisition

Using an External Source

Programmable Power-Up States

DI Change Detection

DI Change Detection Applications

Getting Started with DIO Applications in Software

Counter Input Applications

Counting Edges

Buffered (Sample Clock) Edge Counting

Single Pulse-Width Measurement

Period Measurement

Buffered Period Measurement

Semi-Period Measurement

Frequency Measurement

Low Frequency with One Counter (Averaged)

Large Range of Frequencies with Two Counters

Choosing a Method for Measuring Frequency

Position Measurement

Measurements Using Quadrature Encoders

Measurements Using Two Pulse Encoders

Buffered (Sample Clock) Position Measurement

Single Two-Signal Edge-Separation Measurement

Counter Output Applications

Single Pulse Generation with Start Trigger

Pulse Train Generation

Finite Pulse Train Generation

Frequency Division

Counter Timing Signals

Routing a Signal to Counter n Source

Routing a Signal to Counter n Gate

Counter n A, Counter n B, and Counter n Z Signals

Counter n Internal Output and Counter n TC Signals

Counter Triggering

780214-01