National Instruments NI 7340 Getting Started

Also see for NI 7340: Getting started Getting started Getting started Getting started Getting started

Contents

National Instruments NI 7340 Getting Started Manual pdf 21 page image

Getting Started with NI 7340/7350 Controllers and AKD Drives | © National Instruments | 21Figure 14 shows three-phase connection.Figure 14. AC Input Power Three-Phase ConnectionFigure 15 shows single-phase connection.Figure 15. AC Input Power Single-Phase ConnectionStep 7: Connect the Drive CommunicationComplete the following steps to set up the drive for software configuration using Ethernet. Thesesteps assume you are connecting the AKD servo drive using a hub, switch, or router usingDHCP. If you cannot use DHCP, refer to Connecting to the PC Using a Static IP in the Tips andTroubleshooting section for instructions about direct connection using a static IP address.1. Set S1 and S2 on the drive to 0 to configure the drive for DHCP mode. The drive obtainsan IP address from an external DHCP server if one exists on the network. If no DHCPserver is present, the drive assumes an automatic private IP address in the form of169.254.x.x. This process may take up to a minute to complete. Figure 9 shows thelocations of S1 and S2.2. Connect the AKD servo drive X11 service port to a hub, switch, or router using an Ethernetcable.DCOutL1User-ProvidedFilter(Optional)L2L3AKD Servo DriveProtectiveEarthL1L2L3ProtectiveEarthL1 User-ProvidedFilter(Optional)L2L3L1Neutral (L2)ProtectiveEarthProtectiveEarthDCOutAKD Servo Drive