National Instruments NI PXIe-1075 User Manual

Also see for Network Adapter NI PXIe-1075: User manual

National Instruments NI PXIe-1075 User Manual Manual pdf 37 page image

3-4 | ni.comChapter 3 MaintenanceInstallationEnsure that there is no visible damage to the new power supply shuttle. Verify that the housingand connector on the new power supply shuttle have no foreign material inside. Remove theprotective cap on the PXI_CLK10 connector. Install the new power supply shuttle into theopening on the rear of the chassis. Replace and tighten the ten screws with a Phillipsscrewdriver.ConfigurationThe fan-speed selector switch is on the rear panel of the power supply shuttle. Refer toFigure 1-2, Rear View of the NI PXIe-1075 Chassis, to locate the fan-speed selector. SelectHigh for maximum cooling performance (recommended) or Auto for quieter operation. Setthe Inhibit Mode switch to the Default position.Connecting Safety GroundRefer to the Connecting Safety Ground section of Chapter 2, Installation and Configuration.Connecting to Power SourceRefer to the Connecting to Power Source section of Chapter 2, Installation and Configuration.