National Instruments NI Vision NI 17xx User Manual

Also see for NI Vision NI 17 Series: User manual User manual

Contents

National Instruments NI Vision NI 17xx User Manual Manual pdf 55 page image

Chapter 6 LEDs and DIP SwitchesNI 17xx Smart Camera User Manual 6-6 ni.comNO APP SwitchMove the NO APP switch to the ON position to prevent a startupapplication from running when the NI Smart Camera powers on. If youwant to permanently disable the application from running when the smartcamera powers on, you can disable the startup application in software.To automatically run an application when the smart camera powers on,keep the NO APP switch in the OFF position. You must configure theapplication in software to automatically run when the smart camera powerson. Refer to the LabVIEW Real-Time Module Help for more informationabout automatically launching VIs when the smart camera powers on.Refer to the NI Vision Builder for Automated Inspection: ConfigurationHelp for more information about configuring remote target options.Keep the NO APP switch in the OFF position during normal operation.CONSOLE SwitchWith a serial port terminal program, you can use the CONSOLE switch toread device information from the NI Smart Camera during startup, such asthe IP address and firmware version. When the CONSOLE switch is in theON position, the serial port outputs device information and is not availablefor applications. The smart camera reads this switch only when poweringup or restarting and will only display device information during startup.When the CONSOLE switch is in the OFF position, you can use the smartcamera serial port and NI-Serial driver software to send and receive serialdata. The NI-Serial software is installed when you install NI-IMAQ. Whenusing the NI-Serial driver, keep the CONSOLE switch in the OFF positionduring normal operation.Refer to the Connecting to Serial Devices section of Chapter 2, Power andI/O, for more information about using serial communication with the smartcamera.SAFE MODEIP RESETNO APPCONSOLEONSAFE MODEIP RESETNO APPCONSOLEON