National Instruments NI cRIO-905x Series User Manual

National Instruments NI cRIO-905x Series User Manual Manual pdf 27 page image

1. Prepare the surface for mounting the cRIO-905x using the Surface Mounting Dimensions.2. Align the cRIO-905x on the surface.3. Fasten the cRIO-905x to the surface using the M4 screws appropriate for the surface.Note Screws must not exceed 8 mm of insertion into the cRIO-905x. Tightenthe screws to a torque of 1.3 N · m (11.5 lb · in.).Surface Mounting Rear DimensionsFigure 20. 4-slot cRIO-905x Rear Dimensions6x M4 x 0.78.0 mm (0.315 in.)Max Insertion Depth38.79 mm(1.527 in.)24.48 mm(0.964 in.)24.49 mm(0.964 in.)20.33 mm(0.800 in.)20.32 mm(0.800 in.)50.82 mm(2.001 in.)75.89 mm(2.988 in.)116.54 mm(4.588 in.)221.4 mm(8.72 in.)29 mm(1.142 in.)Figure 21. 8-slot cRIO-905x Rear Dimensions328.6 mm(12.94 in.)120 mm(4.72 in.)24.5 mm(0.96 in.)20.3 mm(0.80 in.)20.3 mm(0.80 in.)9x M4 x 0.78.0 mm (0.32 in.)Max Insertion Depth38.8 mm(1.52 in.)50.8 mm(2.00 in.)73.8 mm(2.91 in.)120 mm(4.72 in.)Mounting the Controller on a PanelWhat to Use• cRIO-905x• Screwdriver, Phillips #2NI cRIO-905x User Manual | © National Instruments | 27