National Instruments PCMCIA-232 Getting Started

Also see for PCMCIA Series: Getting started

Contents

National Instruments PCMCIA-232 Getting Started Manual pdf 18 page image

Chapter 2 Installation and VerificationPCMCIA Serial for Windows 952-2 ©National Instruments CorporationYou can use this same applet to uninstall the NI Serial software at alater time if you want to. Refer to Appendix C, Uninstalling the SerialHardware and Software, for more information.3. Click on the Install... button.4. Insert the NI Serial Software for Windows 95 and Windows NT(Setup Disk), and click on the Next button to proceed.5. The software installation wizard begins with the screen shown inFigure 2-2.Figure 2-2. NI Serial Setup ScreenThe setup wizard guides you through the necessary steps to install theNI Serial software. You may go back and change values whereappropriate by clicking on the Back. You can exit the setup whereappropriate by clicking on the Cancel.6. If you need to install your hardware, or if this is your first time to installthe NI Serial software for Windows 95, skip to the next section, Installthe PCMCIA Serial Hardware. Otherwise, continue to step 7.7. If your hardware is already installed, restart Windows 95.Windows 95 should automatically detect your hardware. Windows 95briefly displays one or more New Hardware Found dialog boxes.If no New Hardware Found dialog box appears, follow the steps inAppendix E, Forcing Windows 95 to Detect the Serial Hardware.