National Instruments PXI Series User Manual

Also see for PXI Series: Installation guide User manual User manual User manual

National Instruments PXI Series User Manual Manual pdf 27 page image

2-12 | ni.comChapter 2 Installation and ConfigurationInstalling PXI ModulesComplete the following steps to install a module.1. Make sure the power switch is in the Off (Standby) position.2. Install a module into a chassis slot by first placing the module card edges into the frontmodule guides (top and bottom), as shown in Figure 2-5. Slide the module to the rear of thechassis, making sure that the injector/ejector handle is pushed down as shown in Figure 2-5.3. When you begin to feel resistance, push up on the injector/ejector handle to fully inject themodule into the chassis frame. Secure the module front panel to the chassis using themodule front-panel mounting screws.Note You must install the driver software provided on the NI Driver CD suppliedwith your kit before you can use the modules in the chassis.Figure 2-5. Installing PXI or CompactPCI Modules1 PXI-1033 Chassis2 Injector/Ejector Rail3 Injector/Ejector Handle4 PXI Module1432