GETTING STARTED GUIDENI PXIe-4464DSA Analog InputThis document explains how to install, configure, and set up the NI PXIe-4464 Dynamic SignalAcquisition (DSA) analog input module. Driver support for the NI PXIe-4464 was first availablein NI-DAQmx 9.9.1. For the list of devices supported by a specific release, refer to theNI-DAQmx Readme, available on the version-specific download page or installation media. Todownload NI-DAQmx 9.9.1, visit ni.com/info and enter the Info Code PXIE4464. TheNI PXIe-4464 is available with BNC connectors or Mini-XLR connectors.ContentsElectromagnetic Compatibility Guidelines .............................................................................. 1Unpacking................................................................................................................................. 2Preparing the Environment ....................................................................................................... 2Verify the Kit Contents............................................................................................................. 3Other Equipment....................................................................................................................... 3Install the Software ................................................................................................................... 3Install the Hardware.................................................................................................................. 4Configure the Hardware in MAX ............................................................................................. 5Connect a Signal Source to the NI PXIe-4464 ......................................................................... 6Environmental Management..................................................................................................... 7Worldwide Support and Services ............................................................................................. 7Electromagnetic Compatibility GuidelinesThis product was tested and complies with the regulatory requirements and limits forelectromagnetic compatibility (EMC) stated in the product specifications. These requirementsand limits provide reasonable protection against harmful interference when the product isoperated in the intended operational electromagnetic environment.This product is intended for use in industrial locations. However, harmful interference mayoccur in some installations, when the product is connected to a peripheral device or test object,or if the product is used in residential or commercial areas. To minimize interference with radioand television reception and prevent unacceptable performance degradation, install and use thisproduct in strict accordance with the instructions in the product documentation.