National Instruments PXIe-6672 Installation Manual

Also see for Network Adapter NI PXIe-6672: User manual User manual CALIBRATION PROCEDURE

National Instruments PXIe-6672 Installation Manual Manual pdf 1 page image

INSTALLATION GUIDENI PXIe-6672This guide contains instructions for installing your NI PXIe-6672controller and NI-Sync software.Installing the SoftwareNote Be sure to install the driver software before installing the NI PXIe-6672 hardware.Complete the following steps to install the software:1. Place the NI-Sync CD in your CD-ROM drive.2. Click Install NI-Sync in the window that appears. If no windowappears, run the setup.exe program on the CD.3. Follow the prompts to install the NI-Sync driver.• Select Typical to install the driver and support for thedevelopment environments present on your computer.• Select Custom to manually select which components should beinstalled.4. Reboot the computer when prompted to do so, or shut down thecomputer and install the hardware.Installing the HardwareThe following are general installation instructions. Consult the chassis usermanual or technical reference manual for specific instructions andwarnings about installing new modules.1. Power off and unplug the chassis.2. Locate the System Timing Slot in your chassis. It is marked by eithera square glyph shown in Figure 1, or a square glyph with a circle insideof it, as shown in Figure 2.

/ 4

Related manuals for National Instruments Network Adapter NI PXIe-6672