National Instruments SCC-FT01 User Manual

Also see for SCC-FT01: Quick start guide

Contents

National Instruments SCC-FT01 User Manual Manual pdf 2 page image

SCC-FT01 Feedthrough Module User Guide 2 ni.comitalic Italic text denotes variables, emphasis, a cross reference, a hardware label,or an introduction to a key concept. This font also denotes text that is aplaceholder for a word or value that you must supply.monospace Text in this font denotes text or characters that you should enter from thekeyboard, sections of code, programming examples, and syntax examples.This font is also used for the proper names of disk drives, paths, directories,programs, subprograms, subroutines, device names, functions, operations,variables, filenames, and extensions.SC-2345 SC-2345 refers to both the SC-2345 connector block and the SC-2345 withconfigurable connectors.SCC SCC refers to any SCC series signal conditioning module.What You Need to Get StartedTo set up and use the SCC-FT01, you need the following items:❑ SC-2345/2350 with one of the following:– SCC-PWR01– SCC-PWR02 and the PS01 power supply– SCC-PWR03 (requires a 7 to 42 VDC power supply, not included)❑ One or more SCC-FT01 modules❑ SCC-FT01 Feedthrough Module User Guide❑ SC-2345/2350 User Manual, available at ni.com❑ SCC Quick Start Guide, available at ni.com❑ Read Me First: Safety and Radio-Frequency Interference❑ SC-2345 Quick Reference Label❑ 68-pin E Series DAQ device, documentation, and 68-pin cable of1 or 2 m length❑ 1/8 in. flathead screwdriver❑ Numbers 1 and 2 Phillips screwdrivers