Appendix E SCXI-1120 Cabling© National Instruments Corporation E-3 SCXI-1120 User Manual5. Connect the loose end of the cable assembly to the MIO-16 board rear signal connector.Check the installation.After step 1, the order of these steps is not critical; however, it is easier to locate the correctposition for the mounting bracket with a module installed in the chassis. If you will attach acable to the breakout connector, installation is easiest if you attach the second cable beforeinstalling the SCXI-1340.SCXI-1120 RearSignal ConnectorRear Panel50-Pin FemaleConnector toMIO-16 BoardMounting BracketMounting BracketConnectorMale BreakoutConnectorStep 3Step 4Step 4Step 5Figure E-1. SCXI-1340 InstallationSCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ and SCXI-1344Lab-LC Cable AssemblyThe SCXI-1341 Lab-NB, Lab-PC, or Lab-PC+ cable assembly connects a Lab-NB, Lab-PC, orLab-PC+ board to an SCXI-1120 module. The SCXI-1344 Lab-LC cable assembly connects aLab-LC board to an SCXI-1120 module. The SCXI-1341 and SCXI-1344 cable assembliesconsist of two pieces–an adapter board and a 50-conductor ribbon cable that connects the Labboard to the rear connector of the adapter board. The adapter board converts the signals from theLab board I/O connector to a format compatible with the SCXI-1120 rear signal connector pinoutat the front connector of the SCXI-1341 or SCXI-1344. The adapter board also has an additionalmale breakout connector that makes the unmodified Lab board signals accessible to anSCXI-1180 feedthrough panel or an SCXI-1181 breadboard module. The adapter board gives the
