National Instruments cRIO-9033 User Manual

National Instruments cRIO-9033 User Manual Manual pdf 34 page image

1. Disconnect power from the cRIO-9033.2. Press the CMOS reset button and hold it for 1 second.3. Reconnect power to the cRIO-9033.The BIOS Reset Detected warning message appears onscreen.Note If the CMOS battery is dead, the CMOS reset button will not work.Power-On Self Test Warning MessagesThe cRIO-9033 POST displays warning messages for specific issues onscreen. You can useMAX to enable Console Out to send these warning messages through the RS-232 serial port.The POST can display the following warning messages:• BIOS Reset Detected—This warning is displayed when the CMOS Reset button has beenpushed. This warning indicates that the BIOS settings have the default values.• CMOS Battery Is Dead—This warning is displayed when the CMOS battery is dead andmust be replaced. The BIOS settings are preserved even when the CMOS battery is dead,but the system will boot very slowly because the BIOS cannot optimize boot time bysaving specific system information to CMOS.BIOS Setup UtilityUse the BIOS setup utility to change configuration settings and to enable special functions.The cRIO-9033 ships with configuration settings that work for most applications, but you canuse the BIOS setup utility to change configuration settings to meet the needs of yourapplication.Changing BIOS settings can cause incorrect behavior, including failure to boot. In general, donot change a setting unless you are sure what the setting does. Reset the BIOS settings torestoring the default configuration settings.Launching the BIOS Setup UtilityComplete the following steps to launch the BIOS setup utility.1. Connect a video monitor to the Mini DisplayPort connector on the cRIO-9033.2. Connect a USB keyboard to one of the USB host ports on the cRIO-9033.3. Power on or reboot the cRIO-9033.4. Hold down either the key or the ~~key until~~ Please select bootdevice: appears onscreen.5. Use the Down Arrow key to select Enter Setup and press . The setup utilityloads after a short delay.The Main setup menu is displayed when you first enter the BIOS setup utility.BIOS Setup Utility Keyboard NavigationUse the following keys to navigate through the BIOS setup utility:34 | ni.com | NI cRIO-9033 User Manual