National Instruments sbRIO-9687 Getting Started Manual

Also see for sbRIO-9607: User manual User manual Getting started guide Getting started

Contents

National Instruments sbRIO-9687 Getting Started Manual Manual pdf 6 page image

Maximum DC input current 8 AF4 Fuse 10 A, 250 VAC, Fast Acting, .25 in. × 1.25 in.Onboard current consumption 0.1 A maxGPIC current consumption 0.75 A maxPreparing the EnvironmentEnsure that the environment in which you are using the sbRIO-9687 meets the followingspecifications.Operating temperature2 (IEC 60068-2-1,IEC 60068-2-2)-40 °C to 85 °CStorage temperature (IEC 60068-2-1, IEC60068-2-2)-40 °C to 85 °COperating humidity (IEC 60068-2-78) 10% RH to 90% RH, noncondensingStorage humidity (IEC 60068-2-78) 5% RH to 95% RH, noncondensingPollution degree 2Maximum altitude 2,000 mIndoor use only.Note Refer to the device specifications on ni.com/manuals for completespecifications.Mounting the HardwareBefore you mount the sbRIO-9687, the thermal kit, sbRIO-9607 controller, and sbRIO-9683 orsbRIO-9684 GPIC must be mounted to a thermally conductive surface at least 3 mm thick.The thermally conductive surface acts as a heat spreader for the sbRIO-9607; ensure a goodthermal contact.Required ToolsThe following tools are required for mounting the sbRIO-9687:• Screwdriver, Phillips #1• Socket driver, 4.5 mm2 Measure the local ambient temperature by placing thermocouples on both sides of the PCB, 5 mm(0.2 in.) from the board surface. Users populating the sbRIO-9687 input termination resistorsshould thermally validate that, in the vicinity of the resistors, the local ambient temperature doesnot exceed 85 °C and the input termination resistor case temperatures and local PCB surfacetemperatures do not exceed 125 °C.6 | ni.com | sbRIO-9687 Getting Started Guide