Native Instruments TRAKTOR KONTROL X1 Setup Manual

Also see for TRAKTOR KONTROL X1: Manual Manual Manual

Contents

Native Instruments TRAKTOR KONTROL X1 Setup Manual Manual pdf 37 page image

6. After device driver installation has finished, Windows will display the message Your devi-ces are ready to use.USB hubs may also be used; however Native Instruments cannot guarantee compatibilitywith all USB hubs currently available on the market.During hardware installation, it may be necessary to disable your anti-virus software.5.3 Ready to KONTROLThe X1 has been designed as a ‘plug and play’ device. Thus, once the supporting software isinstalled no other configuration is necessary.► With the X1 connected to your computer via the USB cable, simply open TRAKTOR andyou are ready to get straight into the mix!5.4 Final PreparationsIt is recommended that you follow the order below when switching on your devices:1. Turn on your computer.2. Ensure that the X1 is connected to the computer's USB 2.0 (or later) port.3. Turn on the amplification system (active speakers or power amplifier with passive speak-ers).Later on, when the software is running and you have loaded tracks to TRAKTOR's Decks, grad-ually raise the volume controls while music is playing until a comfortable listening level isreached.Before putting on headphones, always make sure the headphone volume control is set to mini-mum! Then, while playing music, slowly increase the headphone volume until it reaches thedesired listening level.Connecting the TRAKTOR KONTROL X1 HardwareReady to KONTROLTraktor Kontrol X1 - Setup Guide - 37