Nautel NX10 Installation Manual

Nautel NX10 Installation Manual Manual pdf 44 page image

NX10 INSTALLATION MANUAL COMMISSIONING TASKSPAGE 2.8.2 VERSION 2.0 2016-05-06CommissioningNOTE: The following procedures require the use of the transmitter’s front panel UI and pushbuttons(see Figure 2.8.1). If you require assistance to navigate the front panel, refer to the NX10 Operations &Maintenance Manual for detailed information.Figure 2.8.1: Front Panel User InterfaceTurning on the Transmitter1. Switch on the ac power at the service entrance to turn on the transmitter.NOTE: You may notice a flashing amber light on the control/interface PWB behind the front door.This is the CPU OK LED and it is indicating that the microcontroller is operating normally.2. Check the alarm and status indications on the front panel UI’s Main Menu -> View Status ->View Alarms menu. See the NX10 Operations & Maintenance Manual or the NX10Troubleshooting Manual for detailed information.3. Check the output of the +5, +15 and -15 V power supplies on the front panel UI’s Main Menu ->View Status -> View Meters menu. Scroll through the appropriate sub-menu (Controller, Rack,etc.) to locate the meters.Forward Power Preset 1RF On RF Off Local RemoteStatus LEDsSwitches