168. Connection of Optional Pump-Out Hose:If your machine has the Optional Auto Pump-Out System you may want to connect the Pump-Out Hose.The pump-out hose is a 50’ section of 3/4” garden hose. (Use of smaller diameter hose may reduce flow.)• Remove the cap from the pump-out outlet fitting on the back of the machine.• Connect the pump-out hose to the outlet fitting.• Place the other end of the hose in a commode or drain connected to the sanitary sewer system.• Secure hose end to prevent movement during pumping. Use defoamer to prevent foam build-up in recovery tank during cleaning and to keepfoam/moisture from entering vacuums. Use Hydro Filter II inline filter to trap and remove debris from the waste water before itenters the recovery tank. Excess debris in recovery tank may clog Pump-Out filter. CleanFilter as needed during use. Do not turn the Waste Pump switch ON unless pump-out hose is connected and has beenrouted to a proper drain. The Waste Pump does not use a float switch and will run as soon as the Waste Pump switchis turned ON. It is made to run continuously while cleaning, as this type diaphragm pumpcan run dry without damage.When ready to begin cleaning, turn the Waste Pump switch to the ON position.If not using the waste pump-out, the pump-out hose does not need to be connected. When the recovery tankfills during cleaning, the float assembly in the vacuum inlet filter will rise and will automatically shut off thevacuum air flow to prevent the recovery tank from overfilling and waste water from getting into the vacuums.When this occurs:• Immediately shut off the vacuum switches.• Drain the recovery tank.o Turn off the pump switch while draining the tank.o Turn pump switch back upon resumption of cleaning.• Close the drain valve and turn the vacuum switches back on whenready to resume cleaning.If the pump-out or vacuum shutoff is not working properly, refer to thetrouble shooting guide or contact your distributor for advice or assistance.Connect theFemale GardenHose Fitting endof the Pump-outHose to the outletfitting on the backof the recoverytank. Place theother end of thepump-out hose ina sanitary drain.Float Shutoff AssemblyDraining the Recovery TankPump-out Filter