42MAINTENANCERead all maintenance instructions fully before you start any repair work. In some conditions, an assistant is required to do thenecessary tasks.Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regularmaintenance is done. Worn or damaged components must be repaired or replaced immediately. Only manufacturersupplied components can be used to maintain and repair the equipment.If at any time the Warning labels become loose, unreadable or dislodged, contact your local distributor for replacementlabels.To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cordfrom the wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place thepower cord in a secure location.Daily: Before each use, examine the exercise machine for loose, broken, damaged, or worn parts.Do not use if found in this condition. Repair or replace all parts at the first sign of wear or dam-age, except for the Walking Deck. The Walking Deck is designed for wear on both sides of it.If only one side of the Walking Deck is worn, a replacement Deck is not required. It is recom-mended that a qualified service technician is used to flip the Walking Deck. After each work-out, use a damp cloth to wipe your machine and Console free of moisture.With the Walking Deck lowered, if an edge of the Walking Belt can be seen adjust it untilthe edge is not viewable.Note: Avoid excessive moisture on the Console.Weekly: Check for smooth roller operation. Wipe the machine to remove dust, dirt, or grime.Do not remove the Motor Control Board (MCB) Cover, dangerous voltages and movingparts are present. The components are serviceable only by approved service personnel.Note: Do not use petroleum based products.Monthlyor after 20 hours:Make sure all bolts and screws are tight. Tighten as necessary.Quarterly: Or after 25 hours—Lubricate the walking belt with a silicone-based lubricant.NOTICE: Do not clean with a petroleum based solvent or an automotive cleaner. Be sure to keep the Console free ofmoisture.CleaningTo reduce the risk of electrical shock, always unplug the power cord and wait 5 minutes before cleaning,maintaining or repairing this machine.Wipe the treadmill down after each use to keep the treadmill clean and dry. It may be necessary to use a mild detergent attimes to remove all dirt and salt from the belt, painted parts and the display.NOTICE: To prevent damage to the finish of the machine or Console, do not clean with a petroleum based solvent. Donot apply too much moisture to the Console.