Navico Broadband 4G Installation Manual
                                  | |
Contents
| 
| 11Installation | Broadband 3G/4G™ Radar Installation GuideConnect interconnection cable to the scannerThe scanner interconnection cable connects the scanner to the RI10 interface box (or LowranceHDS via and ethernet adapter cable - 3G U.S only). The cable connects to the scanner using a14 pin connector.• Protect the connectors when pulling cable through the boat and avoid putting strain onto the connectors• The interconnection cable is 9 mm in diameter. A 14 mm hole will be required in orderfor the RJ45 connector to pass through (Interface box end) or 24 mm for the scanner endconnector• Run the interconnection cable between the scanner and the location of the radar inter-face box• Insert cable connector on to the male 14 pin plug on the scanner• Take care to align the connector correctly to avoid bending the pins. Secure the lockingcollar by rotating clockwise until it clicks• Feed and secure the cable into the cable retention channelScanner Interconnection cable pin outScanner connectorCable connectorDiameter = 23 mmPin-out Wire color RJ451 Black Tinned wire2 Red Tinned wire3 Yellow Tinned wire4 Drain Tinned wire5 N/A N/A6 Blue RJ45 Pin 47 White / Blue RJ45 Pin 58 White / Brown RJ45 Pin 79 Brown RJ45 Pin 810 White / Green RJ45 Pin 311 N/A N/A12 White / Orange RJ45 Pin 113 Green RJ45 Pin 614 Orange RJ45 Pin 2 |
Related manuals for Navico Broadband 3G
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine