Navien NPE-180A Quick Installation Manual

Also see for NPE-180A: Installation manual Installation & operation manual Specification sheet Installation manual Service manual

Contents

Navien NPE-180A Quick Installation Manual Manual pdf 4 page image

Opened Closed20 Goodyear, Irvine, CA 92618Tel: (949) 420-0420, Fax: (949) 420-0430Operating the Water HeaterAdjust Water TemperaturePower ON View Basic Information Resetting the Water HeaterOpenTemperature will appear on theFront Panel when the power is on.Press (+) or (-) to setthe desired temperature.Press (+) or (-) to switchthe information type.Press Reset to solvethe problem.NG : 3.5”~10.5” WCLP : 8.0”~13.0” WCThe instructions on how to check the inlet gasfound in thepressure are stated above.filter of any trapped debris.Note If resetting does not solve the problem,Not Setting over 125°F cancause scaldingerefer to the troubleshooting section of theOperation or contact the service center.Remove 4 screws of thefront cover assembly.Loosen a screw two or threeturns and connect a manometerto the pressure port.Recommend Gas Pressure Settings:

/ 4

Related manuals for Navien NPE-180A