Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Navig[8]r NAVBIKE-GPS User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Contents
  1. user manual
  2. Table Of Contents
  3. Important safety instructions and precautions
  4. Setting your user information - The SET screen
  5. Unit of Measure
  6. Night (Backlight)
  7. Chime
  8. Alarm
  9. Short Cuts
  10. Bike
  11. GPS Hints and Tips
  12. Charging the Battery
  13. Using the PC link software (Quick Start Guide)
  14. Time Zone Table / FAQ
Navig[8]r NAVBIKE-GPS User Manual Manual pdf 9 page image
USER MANUAL NAVBIKE-GPS9 | P a g eOFF.9.5 Then, repeat the above steps from 9.1 to move to and set the alarms for each of the 5alarm settings as needed. Then press the MODE button to return back the sub-menuALRM screenNote 1: When the alarm sounds it will sound for 20 seconds. Press any button to stop the alarm.This will stop the alarm without activating any other functions.Note 2: When any alarm is set, an alarm icon will appear on the display.Note 3: The below section 10.0 follows from point 9.0 above.Note: Press the ST/STP/+ button to move to the ODO settings.ODO (Odometer)10.0 Use the ST/STP/+ button to then move to the ODO screen.Enter the screen by pressing VIEW/LAP. A 5 digit number willappear with the far right digit flashing.10.1 Use the ST/STP/+ button to advance this number (from 0 to 9)or the LIGHT/SET/- button to subtract the number (from 0 to 9)10.2 Press the VIEW/LAP button to move to the next field (to theleft) and repeat the process to change each number. Press theMODE button when finished and to return to the main ODO screen.Note 1: The below section 11.0 follows from point 10.0 above.Note 2: Press the ST/STP/+ button to move to the AUTOLAP settings.Setting AutoLap (Distances)Note: Use this feature to use GPS tracking (discussed later in this user manual) to measurepredetermined (race track) distances.11.0 Use the ST/STP/+ button to then move to the AUTOLAP screen. Enter the screen bypressing VIEW/LAP.11.1 Use the ST/STP/+ button to toggle between the following popular track lengths:0.4, 1, 2, 3, 4, and 5 KM and OFF. Press VIEW/LAP to confirm your choice. Then use theST/STP/+ button to select whether to turn the alert ON or OFF.11.2 Press the VIEW/LAP button to confirm your choice and to return back the mainAUTOLAP screen.
/ 17
This manual is suitable for:
NAVBIKE-GPS
Manuals database logo
manualsdatabase
Your AI-powered manual search engine