Navitar 880MCZ087 Installation Instructions Manual

Installation of Navitar/NuView Series 880 lens on Epson model PowerLite 8300iprojector.TOOLS REQUIRED: PHILLIPS HEAD SCREWDRIVER, 3mm Hex (Allen) WrenchDisassembly:1. Disconnect the unit from the power source and place projector with the bottom facingup. Remove four (4) screws (2 on bottom, 1 on each side) holding the lens cover ofthe projector in place. Remove the cover and set aside for reinstallation.2. Flip projector to normal position and remove four (4) socket hex head screws holdingprime lens in place and remove the prime lens.Assembly:1. Ensure that your Navitar lens and its adapter are separate. Using the four (4) sockethex head screws removed in (2) above, install the adapter into the projector.2. Replace the lens cover of the projector removed in step 1, above.3. To focus, gently twist the front of lens. To zoom, loosen thumbscrew and twistknurled ring (zoom lenses only, of course). Re-tighten thumbscrew. CAUTION: Donot twist entire lens out of adapter!

/ 1

Related manuals for Navitar 880MCZ087