Navitar 881MCZ123 Installation Instructions Manual

Navitar/NuView Series 881 lens on NEC GT5000 & GT6000 projectors.TOOLS REQUIRED: PHILLIPS HEAD SCREWDRIVER1) Disconnect unit from power source. Locate and remove four screws that hold thefaceplate in place (two on each side of the face plate in the front). Remove the faceplate.2) Looking on the inside of the faceplate remove any two adjacent screws of the four thathold the plastic shield in place. Remove the plastic shield and set it aside (you will not bereinstalling it). Replace the two screws.3) Insert the Navitar lens mounting bracket inside the projector and secure with the screwsthat Buhl provided with your lens.4) Replace the front faceplate. Insert the Buhl lens through the opening in the projector andscrew it into the mounting bracket.5) To zoom the lens, rotate the raised ring in the middle. To focus, rotate the outermost partof the lens. You will notice the entire lens screwing in and out of the projector. Be careful soas to not unscrew the lens all the way out.

/ 1

Related manuals for Navitar 881MCZ123