Navman Lone Worker Installation Manual
                  | |
Contents
| 
Lone Worker Solution | Installation Manual144 Commission Testing4.1 Configuration and Activation of Lone Worker SolutionVerify with Navman Wireless Technical Support that the Qube has been correctlyconfigured for connection to the Lone Worker Solution.Verify with Navman Technical Support that the “Ack Back” system has been activated4.2 Charge the Pendant1. Align the Pendant with the Charging Dock, with the buttonsat the front. Push the Pendant firmly into the Charging Dock,as shown.The Pendant sounds and ascending/descending tone when ithas docked successfully.2. The RED and GREEN LEDs flash alternately once a secondwhile the battery is charging. This can take up to 2 hours.3. When the battery is charged, the GREEN LED slowly fades onand off. The Pendant remains in a low power state until it isremoved from the Charging Dock.4.3 Check the Ignition ConnectionCheck that the Red wire of the Main Power Harness is connected to the same main powerconnection as the Qube.4.4 Test the Pendant High Priority Alert FunctionWhen the Pendant battery is fully charged, check that the Pendant can communicate withOnlineAVL2 correctly as follows:1. Park the vehicle outside, in a location with a clear view of the sky and good cellularcoverage.Note: If there is no cellular coverage area but the vehicle has a Q-Pro modem, anyHigh Priority Alerts will be sent by satellite.2. Log into OnlineAVL2 then call the Navman Wireless Support Team for assistance withcommissioning the Lone Worker Solution for this particular vehicle. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine