Neilsen CT2230 User Manual
         | |
SKETCH OF OUTLINE NOTICE ITEMSPlacement of welder1. Please set it in less-vibration and flat place above 200mm away fromthe wall.2. Please put in clean and dry place less of iron-power, dust and paint.3.Place it in the site avoiding rain or sea-water erosion.Connection1.Gounda. There is ground terminal under the shell board. Pleaseground with copper wire over 14mm.b. Please arrange the expert or electrician to ground.2. Power connectionModel Sectional area ofoutput cable(mm )2Sectional area ofoutput cable(mm )2 Air swicth current(A)CT2228CT2229CT2230606075Each welder need be equipped with a distributor box with switch andover-current protection device. Please lead the power from the distributorbox to input terminal of welder by cable . The capacity of distributor boxand corss -sectional area of cable refer to below table.? The above cable has copper coil.3 102 19 8763512214111. Wheel 2. Base bracket 3. Wind vent 4. Torch tie-in5. Workpiece tie-in 6. Hand wheel 7. Temperature indicator8. Power indicator 9. Power switch 10. Handle lever11. Power contorl screw≥4≥6≥10≥25≥35≥5023 4 |
Related manuals for Neilsen CT2230
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine