N10 Demo Board User GuideCopyright © Neoway Technology Co., Ltd 63.3.2 Serial port debugging, with DC power supplyThrough DC power supply connection method is as shown below picture, while move power switch awayfrom the 5V DC power supply side, and disconnect jumper connection, then, it can supply power to themodule. At this moment, press the ON / OFF button more than 1.2s, the module can be power on normal,and this time through the serial port tool SScom32 / SScom42/tera term can be used for debugging.

Overview

N10 Development board interfaces

Power and Serial port development board

M5X0-PWR serial port board

Product debugging

Serial port debugging, with DC power supply

Availabel list of accessories

Neoway N10 User Manual

About This Document

Specifications

Pin Description and PCB Foot Print

Pin Definition

PCB Foot Print

Interface Design

Figure 3-1 Current peaks and voltage drops

Figure 3-3 Reference design of power supply control

VIO28

Power-On/Off Control and Procedure

Figure 3-7 Power-on procedure

Figure 3-8 Power-off procedure

RESET

UART

Figure 3-13 Recommended level shifting circuit 1

Figure 3-14 Recommended level shifting circuit 2

DTR and RING

RING Signal

SIM Card

LIGHT

Audio

Figure 3-21 Reference design of MIC differential connections

RF Design and PCB Layout

Recommended RF Connection

Figure 3-26 Encapsulation specifications of Murata RF connector

Electric Features and Reliability

Current

ESD Protection

RF Features

Receiving Sensitivity

Mounting the Module onto the Application Board

Package

Abbreviations