|
Neo_WM620 WCDMA Module AT Command SetCopyright © Neoway Technology Co., Ltd 35Remarks N/A5.5 Setting the New Message SMS Indications Mode: +CNMIDescription To set the mode how the module indicates new SMS messages received from the networkto usersFormat AT+CNMI=e>[,[,[,[,]]]] AT+CNMI? AT+CNMI=?Parameter : Set the indication mode after receiving SMS messages.0: Buffer unsolicited result codes in the TA. If TA result code buffer is full, indications canbe buffered in some other place or the oldest indications may be discarded andreplaced with the new received indications.1: Discard indication and reject new received message unsolicited result codes whenTA-TE link is reserved (e.g. in on-line data mode). Otherwise forward them directly to theTE.2: Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in on-linedata mode) and flush them to the TE after reservation. Otherwise forward them directly tothe TE.3 Forward unsolicited result codes directly to the TE. TA-TE link specific inbandtechnique used to embed result codes and data when TA is in on-line data mode.: Set the format of the new SMS indication codes. The default value is 0.0: SMS indication codes will not be sent to the TE.1: The format of the new SMS indication codes is +CMTI: "MT" ,. The SMSmessage is stored rather than directly displayed.2: The format of the new SMS indication codes is+CMT :,,,,,[,], (text mode). SMS messages are directly displayed rather than stored.3: Use the report codes defined by =2 to transmit SMS indication codes to the TE.The SMS indication codes in other modes are the same as that of =1.: Set the format of the new cell broadcast codes. The default value is 1.0: Not send the indication information of new cell broadcast. The cell broadcast will not bestored.1: The cell broadcast indication code is +CBMI:" BC" , and the cell broadcast isstored.2: The format of the new cell broadcast indication codes is,[,][,,] (text mode). The cellbroadcast will be directly displayed rather than stored.3: The CBM of the third-type information will be displayed on the end device using thereport codes defined by =2. For other type SMS messages that support CBM storage,the indication codes are the same as that of =1.: Report status of SMS message sending. The default value is 1.
|
