Netopia 4622 T1 Getting Started Manual

Netopia 4622 T1 Getting Started Manual Manual pdf 37 page image

Easy Setup 6-117. Toggle IP Address Serving to On or Off, depending on whether you want the device’s IP address server tosupply dynamic IP addresses to your client workstations. Normally, you would accept the default On so thatworkstations on your LAN can have IP addresses assigned dynamically from the router.8. The IP address server will provide 100 IP addresses automatically to workstations on your LAN. You onlyneed to change the Number of Client IP Addresses if you have some other IP addressing scheme.9. By default, the 1st Client Address is 192.168.1.100, based on the device’s default IP address of192.168.1.1. You only need to change this if you have some other IP addressing scheme.10. Press the Down arrow key until you reach NEXT SCREEN. Press Return.Easy Setup Security ConfigurationThe Easy Setup Security Configuration screen lets you password-protect your Netopia 4622. Input your WriteAccess Name and Write Access Password with names or numbers totaling up to eleven digits.If you password protect the console screens, you will be prompted to enter the name and password you havespecified every time you log in to the console screens. Do not forget your name and password. If you do, youwill be unable to access any of the configuration screens.Additional security features are available. See the Firmware User’s Guide chapter on “Security”.The final step in configuring the Easy Setup console screens is to restart the Netopia 4622, so that theconfiguration settings take effect.1. Select RESTART DEVICE. A prompt asks you to confirm your choice.2. Select CONTINUE to restart the Netopia Router and have your selections take effect.Note: You can also restart the system at any time by using the Restart System utility in the Utilities andDiagnostics menu, or by turning the Netopia Router off and on with the power switch.Easy Setup Security ConfigurationIt is strongly suggested that you password-protect configuration access to yourNetopia. By entering a Name and Password pair here, access via serial,Telnet, and SNMP will be password-protected.Be sure to remember what you have typed here, because you will be prompted forit each time you configure this Netopia.Write Access Name:Write Access Password:PREVIOUS SCREEN TO MAIN MENU RESTART DEVICEConfigure a Configuration Access Name and Password here.