MAINTENANCE Page13/168 MAINTENANCE8.1 Grille changingRemove 6 screws (Tx30) and the bumper. Remove 8 screws (TX25) on the side, top and below to remove thegrille.8.2 Haut-parleur 15’’Remove 16 screws (Tx25) to remove the trap. Remove 8 screws (TX25), use a TX25 wrench to unscrew the 2screws located at the front.

WARNINGS

MSUB15 RIGGING

MSUB15 - ACCESSORIES

DESCRIPTION

ARRAY EQ

MAINTENANCE

spare parts

TECHNICAL SPECIFICATIONS

USER NOTES

Nexo MSUB15 User Manual

PLEASE READ CAREFULLY BEFORE PROCEEDING

INTRODUCTION

MSUB15 connectors

C ABLING

CONNECTION DIAGRAMS

3.3 GEO M10 / NXAMP4

3.6 GEO M10 / NXAMP4

M ODE / NXAMP4 X 4 (4 CHANNELS )

NS-1 SIMULATION SOFTWARE

CONFIGURABLE DIRECTIVITY DEVICE

GEO M10 HARDWARE SETUP PROCEDURE

Ground Stacking Safety

Contacts

G ENERAL D ESCRIPTION 6.2.1 GEO M1012 and GEO M1025

GEO M10 "Left" and "Right" configuration

Accessories

WARNINGS ON GEO M10 & MSUB15 ACCESSORIES

G ROUND S TACK SETUPS 6.3.1 Described configurations

GEO M10 only on Lightweight Bumper

GEO M10 only on Touring Bumper with stacking extensions

MSUB15 and GEO M10 with Ministack adaptor

MSUB15 and GEO M10 on Touring Bumper with stacking extensions

F LOWN CLUSTERS SETUPS

GEO M10 only flown with Lightweight Bumper

GEO M10 flown with Touring Bumper

MSUB15 flown with Touring Bumper

MSUB15 and GEO M10 flown with Touring Bumper

T ESTING AND M AINTENANCE OF THE SYSTEM

GEO M10 V ERTICAL C LUSTER DESIGN

D RIVING THE MSUB15 S FROM THE AUX SEND

GEO M1012 & GEO M1025

GEO M10 ACCESSORIES

VNT-EXBARM10

VNT-GSTKM10L

VNT-GSTKM10S

VNT-MNSTKM10

GMT-LBUMPM10

GMT-EXBARM10L

GMT-FLGM10

MST-WBMSUB15

MST-COVMSUB15

MST-2CASEMSUB15

GMT-3CASEM10

GMT-6CASEM10

MSub15


Contents Table Of Contents WARNINGS MSUB15 RIGGING MSUB15 - ACCESSORIES DESCRIPTION ARRAY EQ MAINTENANCE spare parts TECHNICAL SPECIFICATIONS USER NOTES	MAINTENANCE Page13/168 MAINTENANCE8.1 Grille changingRemove 6 screws (Tx30) and the bumper. Remove 8 screws (TX25) on the side, top and below to remove thegrille.8.2 Haut-parleur 15’’Remove 16 screws (Tx25) to remove the trap. Remove 8 screws (TX25), use a TX25 wrench to unscrew the 2screws located at the front. Previous Next / 16