Nextek 4-Blade Vari-Fan Installation And User Manual
Also see for 4-Blade Vari-Fan: Installation and user manualUser manual
                   | |
WARNING: Failure to install the retain clip tightly against the hub asdescribed may cause separation of the hub during fan operation. Seriousinjury may result. Consult a qualified installer if in any doubt aboutinstallation procedures.7.4.12 Push retaining knob onto motor shaft until it is firmly against the hub.7.4.13 Your fan is ready to run.7.4.14 If wired and installed properly, fan blades will rotate counter-clockwise and produce downward draw.7.4.15 For reverse or upward draw operation, blades need to beremoved, inverted and re-attached. Then use reverse button on SpeedController. Blades should rotate clockwise.7.5 Fan Assembly Down Rod VersionFollow the instructions below for installation of down rod ceiling fan.7.5.1 Remove mounting bracket (#01) from mountingcone. (#03) Leave the screws in the bracket thatmatch up with the open hole on each side ofmounting cone.7.5.2 Attach mounting bracket to junction box ordirectly to ceiling using screws taped tomounting bracket. Lead wires through centerhole in bracket.7.5.3 Put down rod (#07) through mount cone (#03) (pivot ball endof rod remains in cone). Please Note: Down Rod can beshortened by cutting to length desired and drilling a 9/32 hole½’ (13mm) from end of down rod.7.5.4 Remove pin and clip (#08) from receptacle.7.5.5 Feed wires from receptacle (#11) through bottom of downrod (#07) and out through the pivot ball end.7.5.6 Slip down rod into receptacle, and align holes of rod withhole in receptacle.Copyright 2012 all rights reserved by Nextek Power Systems, Inc. in the United States and in other countries throughout the world. 13Vari-Cyclone Ceiling Fan Installation ManualModels: 3/4-Blade Vari-Cyclone7.0 INSTALLATION PROCEDURE |
Related manuals for Nextek 4-Blade Vari-Fan
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine