Nidec Control Techniques Digitax-SF Series Instruction Manual
                                                                                                                                                                                                                                                                                                                                                                                                  | |
53. PreparationDigitax SF Instruction Manual1. Installation2. Drive InstallationDo not turn on the AC Supply or the control poweruntil all wiring work is completed.When installing drives, maintain required clearances forprotective enclosures and control panels for heat dissipationand air flow.- Install all drives vertically. Use M5 screws at two locations to mount 50 W to 750 W drivesand three locations to mount 1 kW to 2 kW drives.2 Specifications: Drive Dimensions- If you are mounting the drive into an enclosure such as protective casing, use a fan or air conditionerso that the ambient temperature inside will not exceed 50 °C.- The temperature of the heat sink at its surface may become 30 °C (or more) higher than the ambient temperature.- Use heat resistant wiring materials and keep drives away from heat-sensitive equipment and wiring.- The service life of each drive depends on the ambient temperatures of the internal electrolytic capacitor.Electrolytic capacitors last approximately 5 to 6 years under the conditions of 30 °C annual average temperature,80 % load factor, and 20 hours or less average daily operation.EnclosureExhaust directionVertical direction50 mm or more50 mm or more30 mm or more30 mm or more10 mm or more10 mm or more10 mm or moreMounting Orientation and Clearance |
Related manuals for Nidec Control Techniques Digitax-SF DA21223
This manual is suitable for:
Control Techniques Digitax-SF DA21223Control Techniques Digitax-SF DA22423Control Techniques Digitax-SF DA23823Control Techniques Digitax-SF DA24A23Control Techniques Digitax-SF DA26B23Control Techniques Digitax-SF DA28C23Control Techniques Digitax-SF DA2YZ23Control Techniques Digitax-SF DA2Z123Control Techniques Digitax-SF MH102 2 SeriesControl Techniques Digitax-SF MH152 2 SeriesControl Techniques Digitax-SF MM102 2 SeriesControl Techniques Digitax-SF MM152 2 SeriesControl Techniques Digitax-SF MM202 2 SeriesControl Techniques Digitax-SF MX201 2 SeriesControl Techniques Digitax-SF MX401 2 SeriesControl Techniques Digitax-SF MX751 2 SeriesControl Techniques Digitax-SF MY101 2 SeriesControl Techniques Digitax-SF MY500 2 SeriesControl Techniques Digitax-SF MZ201 2 SeriesControl Techniques Digitax-SF MZ401 2 SeriesControl Techniques Digitax-SF MZ751 2 SeriesControl Techniques Digitax-SF Series
manualsdatabase
Your AI-powered manual search engine