Nidec-Shimpo DT-311J Operation Manual
      |
97541BDT-311J Digital StroboscopeOperation Manualz Do not apply a strong shock or rapid temperature change to unit.Especially, do not leave it where temperature will rise: for instance, ina closed automobile, exposed to direct sunlight, near a stove, openflame, etc.This instrument is water-proof. Do not spray or immerse in water. Donot open and disassemble the unit. Make sure of proper voltage!Do not use stroboscope in an explosive atmosphere as it generateshigh electrical energy pulses.To avoid potential eye damage, do not look directly at flashes.Before operation, make sure there is no damage on the provided ACvoltage line cable. If the cable is damaged, replace it with a new one.To protect against water drips, carefully thread the power cableconnector firmly to the stroboscope. After metal connector of the cablehas been properly fitted onto the body, the power cable can then besafely plugged into a properly grounded AC receptacle.To prevent getting burned, let lamp cool after use before attemptingreplacement.DT-311J NEMA 4X Stroboscope for Harsh Wet Work AreasWhere powerful illumination and rugged speed measuring accu-racy is required for the textile industry, the DT-311J will performwhere other stroboscopes will not. The DT-311J is used to setinjection timing, injection pressure, timing of shedding and weftrunning time of weaving machinery. Units combine rugged NEMA4X (IP65) housing with high performance accuracy, special phaseshifting, with shock absorbing components and top mountedhandle, allows the equipment operator maximum flexibility whensetting the timing of weaving machinery.SPECIFICATIONSPhase Shift: 0 – 359° / 1° incrementsFlash Rate/Phase Angle Setter: Rotary dialDisplay: 4 digit 0.39 in (10 mm) high red LEDDivide Ratio: 1/1, ½, 1/3, ¼, 2/4 with shiftInput Signal: High level: 5-24 V pulse; Low Level: 0-1 V pulse. 2msec minimum. Impedance less than 10k ΩInput Impedance: 47kDisplay Mode: Phase shift (degree), TachometerAccuracy: ±1 digitInternal Signal Range: 200-1500 FPMFlash Range: 200-1500 FPMFlashTube: Xenon lamp Max: 10w at 1,500 rpm. Life: 1,200 hoursat 1,500 rpmPower Requirement: 115VAC±5% 50/60HzPower Consumption: 20VA maxOperating Temperature: 32 to 104°F (0 to 40°C)Product Weight: 4.2 lbs (1.9 kg)Package Weight: 6.2 lbs (2.81 kg)Included Accessories: 19.68’ (6m) input/power cable with con-nector, rubber strobe guard w/ handle1.800.561.8187info@SHIMPO-Direct.ca -Direct.ca |
Related manuals for Nidec-Shimpo DT-311J
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine