Removing the BatteryTurn tile camera offand make sure that tile powerlamp and tile monitor have gone out before openingtile battery card slot cover.To eject tile battery, turn tile orange battery Btch intile direction shown _. Tile battery can then beremoved by hand (2}.• Note that tile battery may become hot during use;observe due caution when removing tile Battery.Turning On and Off the CameraTo turn on tile camera, press tile power switch. Tilepower-on lamp (green) will light for a moment and tilemonitor will turn on.To turn off the camera, press tile power switch again.When tile camera turns off, both tile power-on lampand monitor will turn off.If tile camera is turned off, hold down [] to turn tile camera on in playback mode.[] Auto Power-Off (Standby Mode)• The monitor will dim to reduce the drain on the battery if no operations are performed for aboutfive seconds. The monitor will brighten when camera controls are used. If no operations areperformed for about a minute (default setting), the monitor will turn off automatically and thecamera will enter standby mode. The ca mera will turn off automatically if no operations areperformed for three minutes (Auto off} ([] 125). To turn on the monitor of the standby mode,press the power button or shutter release button.• The standby mode time setting can be changed using Auto off on the setup menu. ([] 125)15