F8Technical Notes and IndexIf the camera fails to function as expected, check the list of common problems below beforeconsulting your retailer or Nikon-authorized service representative.Power, Display, Settings IssuesTroubleshootingProblem Cause/Solution AThe camera is on but doesnot respond.Wait for recording to end.If the problem persists, turn the camera off.If the camera does not turn off, remove and reinsertthe battery or batteries or, if you are using an ACadapter, disconnect and reconnect the AC adapter.Note that although any data currently being recordedwill be lost, data that have already been recorded willnot be affected by removing or disconnecting thepower source.10, 18,E83Camera turns off withoutwarning.• The camera automatically turns off to save power(auto off function).• The camera or batteries have become too cold andcannot operate properly.• The inside of the camera has become hot. Leavethe camera off until the inside of the camera hascooled, and then try turning it on again.19F4–Monitor is blank.• The camera is off.• The batteries are exhausted.• The camera has entered standby mode to savepower. Press the power switch, shutter-releasebutton, A button, c button, or b (e movie-record) button.• The flash lamp flashes while the flash is charging.Wait for the flash to charge.• The camera and computer are connected via a USB cable.• The camera and TV are connected via an audio/video cable or HDMI cable.18181, 194371, 7671, E22
