Nikon F70 Instruction Manual

Nikon F70 Instruction Manual Manual pdf 13 page image

25ully depress shutter release button.ically advances film by one frame, andcreases by one.rture indications in LCD panel andrn off approx. 2 sec. after you releaseur finger off shutter release button.REWINDING FILM1 When film reaches its end of roll, film advance stopsautomatically and shutter locks. · and Y symbol blinkin LCD panel, and · blinks inside viewfinder. (Those symbolsstop blinking and stay on when the exposure meter isautomatically switched off.)Silent film rewindWith the film advance mode set at SL for Single Silent,you can rewind film in very quiet environments. (For filmadvance mode, see p.28).2 Press IN button and Ps button to start film rewind. Duringfilm rewind, U appears on LCD panel, and framecounter counts backwards until rewind is complete.• You can rewind film, before it reaches end of roll, in the samemanner.• If film does not start rewind or if film rewind has stopped atmid-roll, check battery power. If battery power is insufficient,turn power switch off, replace batteries with a fresh set, turnpower on, then press IN and Ps buttons again to restart filmrewind. (When replacing batteries, read "NOTES ONBATTERIES" on page 119.)• Do not open camera back during film rewind. If camera backis opened, film rewind will stop at mid-roll and ‹ and Ublink in LCD panel; to restart film rewind, press IN button andPs button again.3 After rewind automatically stops, confirm the framecounter shows E and film installation symbol T blinks for afew seconds.Open camera back and remove film cartridge.• To remove film, pull out the upper part of the cartridge then liftup.• With an exposed film cartridge left in the film cartridgechamber, depressing shutter release button causes T toblink in LCD panel.To conserve battery power, turn off power switch whenyou are not using the camera. Always remove batteriesbefore storing the camera to prevent damage due toleaking batteries.FUNCTION3 PM Page 24