Niles SI-275 Installation & Operation Manual

Also see for SI-275 Export: Specification sheet

Contents

Niles SI-275 Installation & Operation Manual Manual pdf 13 page image

12INSTALLATIONSpeaker Wire ConnectionsCAUTION! All speaker wire connections must be made with the amplifier Off.Bare WireUnscrew the red orblack plastic knob,insert the bare wireend into the opening,and then tighten theknob until the wire issecurely clamped.Banana PlugsThere are many typesof banana plugs, somecrimp, some solder.The Niles gold bananaplug has a quick-con-nect binding post forthe bare wire on thebody of the plug. Abanana plug is simplyinserted into the jackat the end of the ampli-fier’s binding post.Dual banana plugswill fit the SI-275 bind-ing posts.STEP1. Label all wires.2. Connect one stripped wire end orbanana plug to the black terminaland one to the red terminal.CAUTION- Avoid even a single strandof wire touching the chassis or anotherconnector.DESCRIPTIONIf you label the wires for their destination,rather than which terminal of the SI-275 theyare connected to, it will be easier to recon-figure your system in the future.A. Split the speaker wire insulation so thatat least two inches of each conductor areseparated.B. Strip one half inch of insulation from theend of each conductor of the speaker wireC. Attach banana plugs or twist the strandsof wire together and insert them into theappropriate binding post.