Nilfisk-ALTO SCRUBTEC R 466 User Manual

Contents

Nilfisk-ALTO SCRUBTEC R 466 User Manual Manual pdf 84 page image

USER MANUAL ENGLISH9098960000(1)2011-04 A SCRUBTEC R 466 - R 471 - R 471C - BOOST ® R4 21Cylindrical brush debris container emptying (only for cylindrical brush deck)Stop the machine.14.Lower the cylindrical brush deck and remove the debris container (F, Fig. 2).15.Empty and wash the debris container (F), and then install it on the relevant stand.16.AFTER USING THE MACHINEAfter working, before leaving the machine:Remove the brushes/pad-holders as shown in the relevant paragraph.1.Empty the tanks (19 and 22) as shown in the previous paragraph.2.Remove the squeegee (30) and clean it with hot water.3.Perform the daily maintenance procedures (see the Maintenance chapter).4.Store the machine in a clean and dry place, with the brushes/pad-holders and the squeegee lifted or removed.5.PUSHING/TOWING THE MACHINETo push/tow the machine easily when the drive system cannot be used (for example in case of missing batteries, dischargedbatteries, etc.), disengage the electromagnetic brake by pulling the lever (7) and locking it with a spacer.When the operation is over, remove the spacer under the lever (7) to activate the electromagnetic brake again.WARNING!If the lever (7) is not disengaged after pushing/towing the machine, the electromagnetic brake is disengaged.WARNING!Do not start the machine when the electromagnetic brake is disengaged.For safety reasons, it is recommended to disengage the electromagnetic brake only for the time necessary tomanually move the machine.MACHINE LONG INACTIVITYIf the machine is not going to be used for more than 30 days, proceed as follows:1.Perform the procedures shown in After Machine Use paragraph.2.Before disconnecting the battery red connector (9) perform the following procedures:3.Open the cover (20) and the filler neck (23), then check that the tanks (19 and 22) are empty, otherwise empty them.•Keep the recovery tank assembly (19) lifted by using the stand (25).•FIRST PERIOD OF USEAfter the first 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrityand leakage.