ENGLISH USER MANUAL2 SCRUBTEC 233 9097883000(1)2008-06 AINTRODUCTIONNOTEThe numbers in brackets refer to the components shown in Machine Description chapter.Thank you for choosing a Nilfisk Alto scrubber-dryer.Nilfisk Alto Scrubtec 233 scrubber-dryer is an efficient and superior quality machine for floor cleaning.The machine is equipped with two turning brushes for a cleaning width of 330 mm.Front and rear squeegees clean out the floor, while a vacuum system collects the dirty water, all in one wipe.MANUAL PURPOSE AND CONTENTSThe purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe andautonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. ContactNilfisk Alto in case of doubts concerning the interpretation of the instructions and for any further information.TARGETThis Manual is intended for operators and technicians qualified to perform the machine maintenance.The operators must not perform procedures reserved for qualified technicians. Nilfisk Alto will not be answerable for damagescoming from the non-observance of this prohibition.HOW TO KEEP THIS MANUALThe User Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that can causedamage to it.DECLARATION OF CONFORMITYThe Declaration of Conformity, supplied with the machine, certifies the machine conformity with the law in force.NOTETwo copies of the original declaration of conformity are provided together with the machine documentation.IDENTIFICATION DATAThe machine model and serial number are marked on the plate (1).The machine production year is written in the declaration of conformity and it is also indicated by the first two figures of the machineserial number.This information is useful when requiring machine spare parts. Use the following table to write down the machine identification data.MACHINE model ...............................................................................MACHINE serial number ...................................................................