Nilfisk-Advance 908 4704 010 Instructions For Use Manual

Contents

Nilfisk-Advance 908 4704 010 Instructions For Use Manual Manual pdf 18 page image

16 FLOORTEC 350 146 3083 000(2)2008-11 AENGLISH USER MANUALSKIRT HEIGHT AND OPERATION CHECK1. 'ULYHWKHPDFKLQHRQDOHYHOÀRRUWKDWLVVXLWDEOHIRUchecking the skirt height.2. Turn the main switch (1) to “0”.3. Check that the distance from the ground of the side skirts(A and B, Fig. 11) is 0 - 2 mm.Check the skirts for integrity, cuts or tears, which canreduce the machine vacuum capabilities. If necessaryreplace the side skirts (see the procedure in the ServiceManual).4. Check that the front and rear skirts (C and D, Fig. 11)slightly rub on the ground. Check the skirts for integrity,cuts or tears, which can reduce the machine vacuumcapabilities. Note that the front skirt has typical verticalcuts (E). If necessary replace the front and rear skirts (seethe procedure in the Service Manual).BATTERY CHARGING1. Drive the machine to the appointed recharging area andensure that it cannot move independently.2. Turn the main switch (A, Fig. 12) to “0”.3. Remove the battery charger cable (B) from the housing (C)and connect it to the electrical mains.CAUTION!Before connecting the battery charger (B), ensurethat frequency and voltage values, shown onthe machine serial number plate (33), match theelectrical mains voltage.In case of doubt, do not connect the plug toWKHHOHFWULFDOPDLQVEXWFRQWDFWWKHTXDOL¿HGpersonnel.4. While charging the batteries, the red warning light (D) andthe yellow warning light (E) turn on in sequence.When the green warning light (F) turns on, the batteriesare charged.5. Disconnect the battery charger cable (B) from the electricalmains and place it in the housing (C).NOTEWhen the battery charger is connected to theelectrical mains, all machine functions areautomatically disabled.ADBECCDA-B0-2 mm0-0.08 inS311360Figure 11AFEDBCS311361Figure 12

/ 20

Related manuals for Nilfisk-Advance 908 4704 010