Nilfisk-Advance BR 652 Instructions For Use Manual

Also see for 9087260020: Service manual Instructions for use Service manual

Contents

Nilfisk-Advance BR 652 Instructions For Use Manual Manual pdf 85 page image

USER MANUAL ENGLISHBR 652 - BR 752 - BR 752C 9098684000(3)04/2016 A 23SQUEEGEE CLEANINGNOTEThe squeegee must be clean and its blades must be in good conditions in order to get a good drying.CAUTION!It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.1. Drive the machine on a level floor.2. Insert the ignition key (58) and turn it to “I”.3. Lower the squeegee (30) by pressing the switch (63).4. Turn the ignition key (58) to “0”.5. Disconnect the vacuum hose (31) from the squeegee.6. Loosen the handwheels (34) and remove the squeegee (30).7. Wash and clean the squeegee. In particular, remove dirt and debris from the compartments (A, Fig. 6) and the hole (B). Checkthat the front blade (C) and the rear blade (D) are integral and free from cuts and lacerations; if necessary replace them.8. Assemble in the reverse order of disassembly.SQUEEGEE BLADE CHECK AND REPLACEMENT1. Clean the squeegee (Fig. 6) as shown in the previous paragraph.2. Check that the edge (E) of the front blade (C) and the edge (F) of the rear blade (D) lay down on the same level, along theirlength; otherwise adjust their height according to the following procedure:• Remove the tie rod (G), disengage the fastener (M) and adjust the rear blade (D); then engage the fastener and install thetie rod.• Loosen the handwheels (I) and adjust the front blade (C); then tighten the handwheels.3. Check the front blade (C) and rear blade (D) for integrity, cuts and tears; if necessary replace them as shown below. Check thefront corner (J) of the rear blade for wear; if necessary, overturn the blade to replace the worn corner with an integral one. If theother corners are worn too, replace the blade according to the following procedure:• Remove the tie rod (G), disengage the fastener (M) and remove the retaining strip (K), then replace/overturn the rear blade(D).• Install the blade in the reverse order of removal.• Unscrew the handwheels (I) and remove the retaining strip (L), then replace the front blade (C).• Install the blade in the reverse order of removal.After the blade replacement (or overturning), adjust the height as shown in the previous step.4. Connect the vacuum hose (31) to the squeegee.5. Install the squeegee (30) and screw down the handwheels (34).6. If necessary, adjust the squeegee balance adjusting handwheel (35).AC DBAIKFJEDCLIMGIFigure 6P100367