Nilfisk-Advance BRX 700 Series Instructions For Use Manual

Also see for 56314019: Service manual

Contents

A-12 - FORM NO. 56041541 - AquaRide ™ SE, AquaRide™ SE AXP / BRX 700 seriesA-12 / ENGLISHREMOVING THE BRUSHES1 Turn the Master Key Switch (J) OFF.2 Loosen the Black Knob (A) on top of the idler assembly and remove the idler assembly. Slide the brush out of the brush deck housing.3 To reinstall, slide the brush into the housing, lift slightly, push and turn until it seats. NOTE: Make sure Slots (B) in end of Brush line up with and seatfirmly on Lugs (C) on the Drive End Assembly. Re-install the idler assembly and tighten Black Knob (A).REMOVING THE VACUUM SHOES1 Turn the Master Key Switch (J) OFF.2 Loosen the Black Knob (D) on the back of the scrub deck. Lift theBar (E) up and remove. Slide the vac shoe out of the shoe supportweldment (F). Procedure is the same for both vac shoes.3 Reinstallation is reverse of removal.5 Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to the bottom of the fillertubes.WARNING !Do not fill the batteries before charging.Only charge batteries in a well-ventilated area.Do not smoke while servicing the batteries.CAUTION !To avoid damage to floor surfaces, always wipe water and acid from the top of the batteries after charging.CHECKING THE BATTERY ELECTROLYTE LEVELCheck the electrolyte level of the batteries at least once a week.After charging the batteries, remove the vent caps and check the electrolyte level in each battery cell. Use distilled water to fill the batteries to the bottom ofthe filler tube.Do not over-fill the batteries!CAUTION !Acid can spill onto the floor if the batteries are overfilled.Tighten the vent caps. If there is acid on the batteries, wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking sodato 1 quart of water).CHARGING THE BATTERIESCharge the batteries each time the machine is used, or whenever theBattery Condition Meter (K) is showing a yellow, red or flashing redindicator light(s).To Charge the Batteries...1 Depress the Battery Disconnect (13).2 Open the Battery Compartment Cover (16) to provide properventilation.3 Push the connector from the charger into the Battery Connector (22).4 Follow the instructions on the battery charger. ! " # $ # % & ' ! (