Nilfisk-Advance C 100.6 User Manual

Also see for C 100.6: User manual

Contents

Nilfisk-Advance C 100.6 User Manual Manual pdf 14 page image

14 Original InstructionsENDANOSVFIDEFRNLITESPTELTRCSHUPLHRSLSKLVLTETRUZHIn case problems other than the above occur, please contact your local Nilfi sk distributor. Local Nilfi sk distri-butors are listed on the back cover of this instruction.Customer Service at Penrith – 01768 8689958 Warranty ConditionsNilfi sk guarantees high pressure washers for domestic use for 2 years. If your high pressure washer or ac-ces so ries are handed in for repair, a copy of the receipt must be enclosed.Guarantee repairs are being made on the following conditions:• that defects are attributable to fl aws or defects in materials or workmanship. (wear and tearas well as misuse are not covered by the gu a rantee).• that the directions of this instruction manual have been thoroughly observed.• that repair has not been carried out or attempted by other than Nilfisk-trained service staff.• that only original accessories have been applied.• that the product has not been exposed to abuse such as knocks, bumps or frost.• that only water without any impurities has been used.• that the high pressure washer has not been used for rental nor used commercially in anyother way.Repairs under this guarantee include replacement of defective parts, exclusive of packing and postage/car-riage. Besides, we refer to your national law of sale.The machine should be forwarded to one of the service centres of the Nilfisk organisation with description/spe ci fica ti on of the fault.Repairs not covered by the guarantee conditions will be invoiced. (I.e. malfunctions due to Causes menti-o ned in section Troubleshooting Chart of the instruction manual).Symptom Cause Recommended actionMachine stops Fuse has blownIncorrect mains voltageThermal sensor activatedNozzle partially blockedReplace fuse. Switch off other machines.Check that the mains voltage correspondsto specifi cation on the model tag.Leave the washer for 5 minutes to cooldown.Clean the nozzle (see section 6.2)Fuse blows Fuse too small Change to an installation higher than theamp. consumption of the machine.You may try without the extension cable.Machine pulsating Air in inlet hose/pumpInadequate supply of mainswaterNozzle partially blockeWater fi lter blockedHose kinkedAllow machine to run with open trigger untilregular working pressure resumes.Check that the water supply corresponds tospecifications required (see model tag)NB! Avoid using long, thin hoses (min. 1/2")Clean the nozzle (see section 6.2)Clean the fi lter (see section 6.1)Straighten out hose.Machine often startsand stops by itselfPump/spray handle is leaking Contact your nearest Nilfi sk Service Centre.Machine starts, but nowater comes outPump/hoses or accessoryfrozenNo water supplyWater fi lter blockedNozzle blockedWait for pump/hoses or accessory to thaw.Connect inlet water.Clean the fi lter (see section 6.1)Clean the nozzle (see section 6.2)