Nilfisk-Advance Captor 4300 Instructions For Use Manual

Also see for Captor 4300: Mechanical repair service manual Quick start manual Quick start troubleshooting manual

Contents

Nilfisk-Advance Captor 4300 Instructions For Use Manual Manual pdf 24 page image

A-24 - FORM NO. 56041580 - Captor ™ 4300, 4800, 5400 / CR 1100, 1200, 1400A-24 / ENGLISHFIGURE 5SIDE BROOM MAINTENANCEThe side broom(s) move dirt and debris away from walls or curbs and into the path of the main broom. Adjust the side broom so that thebristles are contacting the oor from the 10 O’clock (A) to the 3 O’clock (B) area shown in gure 5 when the broom is down and running.To adjust the Side Broom...1 The side broom(s) are adjusted simply by pressing and holding the Side Broom DOWN/ON Switch (N) or the Side Broom UP/OFFSwitch (Y) until the desired amount of bristles are contacting the oor.NOTE: The machine should be stored with the Side Broom(s) in the raised position. The Side Broom(s) should be replaced when thebristles are worn to a length of 3 inches (7.62 cm) or they become ineffective.To replace the Side Broom...1 Raise the Side Broom(s).2 Reach under the Side Broom and remove the large Thumb-Nut holding the side broom on and remove the broom and plastic disc.3 Install the new broom and plastic disc by aligning the three alignment pins and pushing on. Re-install the Thumb-Nut and tighten.TOP VIEW OF HOPPER